diff --git a/drivers/net/Kconfig b/drivers/net/Kconfig
index 2a229b8..e0008fd 100644
--- a/drivers/net/Kconfig
+++ b/drivers/net/Kconfig
@@ -13,6 +13,27 @@
 	help
 	  Enable Ethernet PHY (physical media interface) support.
 
+config RTL8211X_PHY_FORCE_MASTER
+	bool "Ethernet PHY RTL8211x: force 1000BASE-T master mode"
+	depends on PHYLIB
+	help
+	  Force master mode for 1000BASE-T on RTl8211x PHYs (except for RTL8211F).
+	  This can work around link stability and data corruption issues on gigabit
+	  links which can occur in slave mode on certain PHYs, e.g. on the
+	  RTL8211C(L).
+
+	  Please note that two directly connected devices (i.e. via crossover cable)
+	  will not be able to establish a link between each other if they both force
+	  master mode. Multiple devices forcing master mode when connected by a
+	  network switch do not pose a problem as the switch configures its affected
+	  ports into slave mode.
+
+	  This option only affects gigabit links. If you must establish a direct
+	  connection between two devices which both force master mode, try forcing
+	  the link speed to 100MBit/s.
+
+	  If unsure, say N.
+
 menuconfig NETDEVICES
 	bool "Network device support"
 	depends on NET
diff --git a/drivers/net/phy/realtek.c b/drivers/net/phy/realtek.c
index 259a87f..359ec50 100644
--- a/drivers/net/phy/realtek.c
+++ b/drivers/net/phy/realtek.c
@@ -12,6 +12,10 @@
 
 #define PHY_AUTONEGOTIATE_TIMEOUT 5000
 
+/* RTL8211x 1000BASE-T Control Register */
+#define MIIM_RTL8211x_CTRL1000T_MSCE (1 << 12);
+#define MIIM_RTL8211X_CTRL1000T_MASTER (1 << 11);
+
 /* RTL8211x PHY Status Register */
 #define MIIM_RTL8211x_PHY_STATUS       0x11
 #define MIIM_RTL8211x_PHYSTAT_SPEED    0xc000
@@ -53,7 +57,14 @@
 	 */
 	phy_write(phydev, MDIO_DEVAD_NONE, MIIM_RTL8211x_PHY_INER,
 		  MIIM_RTL8211x_PHY_INTR_DIS);
-
+#ifdef CONFIG_RTL8211X_PHY_FORCE_MASTER
+	unsigned int reg = phy_read(phydev, MDIO_DEVAD_NONE, MII_CTRL1000);
+	/* force manual master/slave configuration */
+	reg |= MIIM_RTL8211x_CTRL1000T_MSCE;
+	/* force master mode */
+	reg |= MIIM_RTL8211X_CTRL1000T_MASTER;
+	phy_write(phydev, MDIO_DEVAD_NONE, MII_CTRL1000, reg);
+#endif
 	/* read interrupt status just to clear it */
 	phy_read(phydev, MDIO_DEVAD_NONE, MIIM_RTL8211x_PHY_INER);